The world's lightest* 3000 ANSI lumens projector. Auto features to make set up quick and easy.
|
|
| * As of November 2006, according to our investigation. | |
Functions and Features
High brightness of 3000 ANSI lumens in a 1.6 kg lightweight body
High brightness of 3000 ANSI lumens (NP60) is more than sufficient for use in a well-lit room.The lightweight magnesium body is compact and extremely strong making it very durable for the travelling professional.
Auto Focus Function by the focus sensor
The focus of the projected image is adjusted automatically by measuring the distance between the focus sensor and the screen. This function activates immediately whenever the power is turned on, the zoom function is adjusted or the position of the main unit is changed, so the projector can be set up easily without focusing every time.
Auto Vertical Keystone Correction adjusts the trapezoidal distortion to correct the projected image
If the position of the screen is too high or low, the projector must be installed at an angle, resulting in trapezoidal distortion of the projected images. The acceleration sensor built into the main unit senses the inclination of the unit in the vertical direction and then corrects for any trapezoidal distortion in the projected images automatically to project square images. (+/- 16 degrees from the projection angle) The user can set up the projector very quickly and easily since it is not necessary to correct it manually.
Wall Colour Correction enables vivid images even without a screen
Without a screen, the projected images may be affected by the colours of the wall or blackboard. This projector has built-in colour correction for projecting images on a coloured wall or blackboard, so that the colour tones of the projected images can be approximated to those projected on a white screen. The following eight colour options are available as user selections: blackboard, blackboard (gray), light yellow, light green, light blue, sky blue, light rose and pink.
New Cooling System
The NP60/50/40 houses a state of the art new cooling system. This system uses a cooling pump, to pump high pressure / high velocity air around the lamp dramatically improving cooling efficiency. With this new cooling system, the body can be further reduced in size compared with ordinary projectors that use a single cooling fan.
The NP60/50/40 delivers the same high brightness as the previous LT35/30/25 models, while reducing the weight by 20%.
Quick Start Up and Cooling Down
The projector can project images from a PC or a video within approximately 14 seconds after turning on the power. The length of time it takes for the cooling fan to stop after turning off the main power is just 10 seconds, so the projector can be removed and packed away very quickly after a conference or lecture.
Quick power-off function
The quick power-off function permits immediate removal of the power plug from the electrical outlet after turning off the main power even if the cooling fan is still operating. Since it is not necessary to wait for the cooling fan to stop, the projector can be promptly transferred to another room. With the direct power-off function, it is possible to remove the power plug from an electrical outlet even when images are being projected.
Security function prevents unauthorized use or theft
By using passwords, the projector cannot be used by unauthorized persons. Once the Security function is in effect, a message requesting the password is displayed when the power of the main unit is turned on. It is impossible to project an image unless the proper password is entered.
Terminal Panel
Throwing Distance and Screen Size
A link is opened in a new window.Throwing Distance and Screen Size
Specifications
| Model Name | NP60 | NP50 | NP40 | |||
| DLP Chip *1 | 0.55 inch 1 chip DLP, 1,024 x 768 pixels (Aspect 4 : 3) | |||||
| Lens | Manual zoom and auto focus *4 (effective range : 1.5 m to 5.5 m) / manual focus | |||||
| (F2.2 to 2.34, f=20.4 mm to 24.5 mm) | ||||||
| Lamp | Normal Mode | 220W AC | 200W AC | |||
| Eco Mode | 170W | |||||
| Lamp Life *2 | Normal Mode | 2,000H | ||||
| Eco Mode | 3,000H | |||||
| Power Consumption | Normal Mode | 285W | 265W | |||
| Eco Mode | 220W | |||||
| Standby Mode | 6W | |||||
| Input Current | 3.2A to 1.3A (100 to 240V AC) |
3.0A to 1.2A (100 to 240V AC) |
||||
| Light Output *3 | Normal Mode | 3,000 ANSI lumens | 2,600 ANSI lumens | 2,200 ANSI lumens | ||
| Eco Mode | Approx.75% of Normal | Approx.85% of Normal | ||||
| Contrast Ratio (White/Black) *3 | 1,600 : 1 | 1,500 : 1 | ||||
| Quietness | Normal Mode | 40dB | ||||
| Eco Mode | 35dB | |||||
| Image Size | 33inch to 300inch (33inch is only end of tele) | |||||
| Projection Distance | 1.5m to 13.4m | |||||
| Projection Angle | 12.3 degree to 15 degree | |||||
| Maximum Resolution | UXGA (1,600 x 1,200) With scaling technology | |||||
| Synchronization Range | Horizontal | 15kHz to 100kHz (RGB: 24kHz or over) | ||||
| Vertical | 50Hz to 85Hz | |||||
| Video Bandwidth | RGB:100MHz / Video:6.5MHz | |||||
| Colour Reproduction | Full Colour, 16.77Million Colours Simultaneously | |||||
| Input Terminals | 1 Computer Input | D-Sub Mini 15pin | Compatible signals | VGA, SVGA, XGA, SXGA, SXGA+,UXGA | ||
| RGB | 0.7Vp-p/75Ω | |||||
| H/V Sync | 4.0Vp-p/TTL Polarity | |||||
| Composite Sync | 4.0Vp-p/TTL Level | |||||
| Sync on G | 1.0Vp-p/75Ω(With Sync) Negative Polarity | |||||
| 1 Component Input (Sharing With Computer) |
D-Sub Mini 15pin (Sharing With Computer Input) |
Y | 1.0Vp-p/75Ω(With Sync) | |||
| Cb • Cr (Pb • Pr) | 0.7Vp-p/75Ω | |||||
| Compatible signals | 1080i, 720p, 576p, 480p, 576i, 480i | |||||
| DVD Progressive Signals(50/60Hz) | ||||||
| 1 Video Input | RCA pin | Composite signals | NTSC/NTSC4.43/PAL/PAL-N/PAL-M/PAL-60/SECAM | |||
| Composite Video | 1.0Vp-p/75Ω | |||||
| 1 S-Video Input | Mini DIN-4pin | Y | 1.0Vp-p/75Ω | |||
| C | 0.286Vp-p/75Ω(Burst Level of NTSC) | |||||
| Control terminals | PC Control | Mini DIN-8pin | RS-232C | |||
| Keystone Correction Vertical | Automatic/Manual max±16属 | |||||
| Environment | Operational Temperatures | 5°C to 40°C, 20% to 80% Humidity (Non-Condensing)(Eco mode selected automatically at 35°C to 40°C) |
||||
| Storage Temperatures | -10°C to 50°C, 20% to 80% Humidity (Non-Condensing) |
|||||
| Power Requirement | 100 to 240V AC, 50Hz/60Hz | |||||
| Regulations | For North America | UL Approved(UL 60950-1),NOM-001-SCFI-1993, Meets FCC Class B Requirements | ||||
| For Canada | UL Approved(CSA 60950-1), Meets DOC Canada Class B Requirements | |||||
| For Asia/Oceania | Meets IEC60950-1, Meets AS/NZS CISPR.22 Class B | |||||
| For China | GB4943, GB9254,GB17625.1 | |||||
| For Europe | Meets EMC Directive(EN55022, Class B, EN55024, EN61000-3-2, EN61000-3-3), Meets Low Voltage Directive (EN60950-1, TÜV GS Approved) |
|||||
| Net Weight | 1.6kg | |||||
| Dimensions (WxHxD) | 246mm x 72mm x 177mm (Not Including Protrusions) |
|||||
| *1 : | DLP Chip technology consists of fine picture cells with more than 99.99% of the cells being active. |
| *2 : | Lamp life is defined as the average time span for the brightness of the lamp to be reduced by half, it dose not refer to the warranty period for the lamp. |
| *3 : | Compliance with ISO21118-2005 |
| *4 : | Auto focus functions are accurate within the range of approximately 1.5m to about 5.5m. If the throwing distance is 1.5m, the screen size is 33 inches, while at a distance of 5.5m, the screen size is 149 inches.If the distance from the projector to the screen exceeds 5.5m, the focus must be adjusted manually. Depending on the colour of the screens or other environmental conditions, the operational range may be narrowed or the equipment may not operate properly. If a transparent screen is used, malfunctions may occur. Obstacles between the screen and the projector may cause the focus sensor to malfunction. When the main unit is moved slowly, this function may not activate. If the screen is moved, this function may not activate. |
| All specifications are subject to change without notice. | |
Dimensions
Accessories
Soft Case (basic accessory)
Remote Control
Options
Replacement lamp NP03LP
(for NP60) 
Replacement lamp NP02LP(for NP50, NP40)
 |
|
For detailed information, please contact the NEC sales company or dealer in your area.
The images in this web site are samples.
All brand and product names are registered trademarks of their respective holders. Further trademark information